Testimonials

Re-inking Stampers

All of our pre-inked stampers can be re-inked using the appropriate refresher ink. For the Superstamper and Stamp Stack range use only the SS Ink. For the ES Range, Clix and Stick Stars use the ES Ink. GOLD and YELLOW ink are not available for re-inking!

SS Range
  1. To re-ink your SS stamper turn it upside down
  2. Add 2 to 3 drops of refresher ink directly onto the rubber pad. Do not over ink as this will decrease the quality of the image being stamped
  3. Leave the stamper in this position for a few hours (overnight is ideal)
  4. Start stamping again!
ES Range
  1. To re-ink your ES stamper Remove the handle (holding the base and the handle - it will pull apart)
  2. Set the stamper down on a level surface (put a sheet of paper underneath so that you do not mark the surface it's sitting on)
  3. Add 2 to 3 drops of refresher ink to the small well facing upwards. Do not over ink as this will decrease the quality of the image being stamped
  4. Leave the stamper in this upright position for a few hours (overnight is ideal)
  5. Put the handle back on the stamper again
  6. Start stamping again!
Stamp Stacks
  1. To re-ink your Stamp Stack stamper turn it upside down
  2. Add 2 to 3 drops of refresher ink directly onto the rubber pad. Do not over ink as this will decrease the quality of the image being stamped
  3. Leave the stamper in this position for a few hours (overnight is ideal)
  4. Start stamping again!
Clix
  1. To re-ink your Clix Stamper Pen, remove the stamper from the end of the pen (it will pull apart)
  2. Set the stamper down on a level surface (put a sheet of paper underneath so that you do not mark the surface it's sitting on)
  3. Add 1 to 2 drops of refresher ink to the small well facing upwards. Do not over ink as this will decrease the quality of the image being stamped
  4. Leave the stamper in this upright position for a few hours (overnight is ideal)
  5. Put the stamper back on the pen
  6. Start stamping again!
Stick Star
  1. To re-ink your Stick Star Stamper, remove the stamper from the end of the pen (it will pull apart)
  2. Set the stamper down on a level surface (put a sheet of paper underneath so that you do not mark the surface it's sitting on)
  3. Add 1 to 2 drops of refresher ink to the small well facing upwards. Do not over ink as this will decrease the quality of the image being stamped
  4. Leave the stamper in this upright position for a few hours (overnight is ideal)
  5. Put the stamper back on the barrel
  6. Start stamping again!